Crossport Systems Pivio Guía de usuario descargar pdf (Pagina 49)

Static IP Configuration

Linux configuration

Use the following procedure if you are running Linux.

Step 1 Record your current settings

Use “netstat -ni”, “netstat -nr” and “ifconfig” to determine the

interfaces, routing and addresses.

First, you should find the available interfaces:

# netstat -ni

Kernel Interface table

Iface MTU Met RX-OK RX-ERR RX-DRP RX-OVR TX-OK TX-ERR TX-DRP TX-OVR Flg

eth0 1500 0 521478 0 0 0 626019 0 0 0 BRU

lo 16192 0 92498 0 0 0 92498 0 0 0 LRU

In this example, there are two interfaces, the loopback (lo) and the

ethernet (eth0). The ethernet (eth0) is the one to use.

Second, look up the default route:

# netstat -nr

Kernel IP routing table

Destination Gateway Genmask Flags MSS Window irtt Iface

255.255.255.255 0.0.0.0 255.255.255.255 UH 40 0 0 eth0

192.168.1.0 0.0.0.0 255.255.255.0 U 40 0 0 eth0

0.0.0.0 192.168.1.1 0.0.0.0 UG 40 0 0 eth0

The default route (destination 0.0.0.0) towards the IP 192.168.1.1 is

the “gateway.” The other entries are a forced broadcast out the

device eth0 (destination 255.255.255.255) and a “connected”

network (destination 192.168.1.0).

Finally, obtain the IP address for eth0:

# ifconfig eth0

eth0 Link encap:Ethernet HWaddr 00:50:C2:08:50:01

inet addr:192.168.1.5 Bcast:192.168.1.255 Mask:255.255.255.0

UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

RX packets:523211 errors:0 dropped:0 overruns:0 frame:0

TX packets:627431 errors:0 dropped:0 overruns:0 carrier:0

collisions:3561 txqueuelen:100

Interrupt:10 Base address:0xe800

In this example, the address (inet addr) is 192.168.1.5 and the

netmask is 255.255.255.0 (Mask).

Step 2 Set your IP address to 172.30.192.2 and your default gateway to

172.30.192.1

First make sure you have “root” access:

% su

Password: <root password>

Then run ifconfig to set the new IP address. Do not do this

remotely, as you may lose network access to the machine:

# ifconfig eth0 172.30.192.2 netmask 255.255.255.0

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 59 60

Comentarios a estos manuales

Sin comentarios

Crossport Systems Pivio Guía de usuario Pagina 49

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Crossport Systems Pivio