Crossport Systems Pivio Especificaciones descargar pdf (Pagina 96)

14 1/2" Closed Mouth Trailer-Mounted Bucking Unit

Section Contents

8.6

Technical Manual

BEST BY FARR

DISTRIBUTOR COVER SUB-ASSEMBLY: Insert the distributor/motor cover O-ring in the seat in

the bottom of the distributor cover. For distributors with the bronze disc; insert the O-ring and

the plastic slipper with the chamfer on the side of the bottom of the distributor.

ROTARY GROUP ASSEMBLY: Insert distributor drive pin in shaft through the central hole in

motor cover.

NOTE: ENSURE THAT NO OBJECTS FALL INTO COVER. IF THIS HAPPENS IT

WILL BE NECESSARY TO DISMANTLE THE MOTOR TO REMOVE THE OBJECTS.

INSERT THE LOCATING PINS IN THEIR HOLES IN THE MOTOR COVER.

Place the disc on cover, positioning it with the locating pins. Motors without the disc do not have

locating pins.

NOTE: MOTORS PRODUCED BEFORE 7/87 USED .236 INCH PINS. MOTORS PRO-

DUCED AFTER 7/87 USE .196 INCH PINS. A CERTAIN NUMBER OF DISCS PRO-

DUCED HAVE HOLES FOR BOTH TYPES OF PIN AND IT IS IMPORTANT WHEN

PLACING THE DISC THAT IT IS POSITIONED USING THE CORRECT HOLES. THE

DISC MUST SIT FLUSH WITH THE MOTOR COVER. IT DOES NOT NEED TO BE

PRESSED ON AND THE FIVE OIL FEED HOLES MUST LINE UP WITH THE HOLES

IN THE MOTOR COVER. ONCE POSITIONED IT MUST NOT BE ABLE TO ROTATE

OR TO MOVE LATERALLY. INSERT THE CENTERING BUSH IN THE DISC

POSITION THE DISTRIBUTOR ROTARY ON THE DISC WITH THE SIDE CONTAIN-

ING THE SEALS ON TOP AND WITH THE THREE RADIAL HOLES TO THE LEFT

OF THE REFERENCE CYLINDER AND THE THREE AXIAL HOLES TO THE RIGHT.

DISTRIBUTOR COVER ASSEMBLY: Place the distributor cover over the rotary, aligning the bolt

holes in the distributor cover and the motor cover. The distributor can be placed in any one of

the five positions. Screw in and tighten the five bolts.

Hydraulic Motor Service Information

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 114 115

Sin comentarios

Crossport Systems Pivio Especificaciones Pagina 96